# SuArm Swift Pro 2nd uart Firmware

## Document & Support

## To flash the  2nd uart firmware.hex to Swift Pro:

* Find the 2nduart.hex file in the file folder.
* Download and extract [XLoader](http://xloader.russemotto.com/XLoader.zip).
* Open XLoader and select your uArm's COM port from the drop down menu on the lower left.
* Select the appropriate device from the dropdown list titled "Device".
* Check that Xloader set the correct baud rate for the device: 115200 for Mega (ATMEGA2560).
* Now use the browse button on the top right of the form to browse to your hex file.
* Once your hex file is selected, click "Upload"
The upload process generally takes about 10 seconds to finish. Once completed, a message will appear in the bottom left corner of XLoader telling you how many bytes were uploaded. If there was an error, it would show instead of the total bytes uploaded. Steps should be similar and may be done through the command prompt.

## License

Swift Pro Firmware is published under the [GPL license](/LICENSE) 